Rapeseed oil press to further enhance competitiveness in international markets. No oil or oil yield is too low. May be too tight or fitted seams to be diesel oil drain blockage caused by the cage bars. Oil content should be based on the level of tightness cage bars to adjust. Possible by pressing the chamber temperature is too low, the parts wear out the cake thickness caused by inappropriate. Note that the use of screw press. Probably caused by raw water unsuitable materials damp moldy, excessive impurities, seed material and other reasons do not eat. Should be re-elected the fuel, fuel moisture control. Look at boot time, we must pay great attention to, such as reaching a certain temperature, plus materials. Also may be due to oil containing stones and other hard foreign impurities into the virgin bore cause. Once this happens, we should shut down immediately clear bore hard, inspect parts for wear, if the parts wear more serious and should be repaired or replaced immediately. Screw shaft stuck phenomenon caused by a sudden stop. May be due to poor discharge, pressing bore blockage causes. It should be noted homogeneous charge, control the thickness of the cake. Once that happens, you should immediately turn off the power, stop feeding, Chasi feed adjustment board, open nesting plate, out of the helical axis of the bore oil cleanup, all re-pressing upon completion. May also be because the chamber has not yet pressed the hot mill, it put a lot of raw materials caused. Hello! Gongyi City Branch Xin machinery specializing in the production of various types of oil filter, oil press, wok, peanut sheller, hoist and a series of agricultural products, production of product price, model complete, welcomed the consultation purchase.